Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ZiG

Pages: 1 [2] 3 4
16
Automotive Marketplace / Re: WT Borrow - Trailer
« on: December 12, 2017, 10:13:19 AM »
Well I'm off work starting next week so shoot me a PM whenever. We can use my truck, too.

Where are you planning to take it? I'm considering powder coating my racecar chassis too...

17
Automotive Marketplace / Re: WT Borrow - Trailer
« on: December 12, 2017, 09:04:45 AM »
Hmm, how close to 12' is it? I have a 12' utility trailer that might work... The rear ramp does come off so I suppose a 6" overhang wouldn't be the worst thing.

18
Technical Talk / Re: Possible system enhancement
« on: November 05, 2017, 09:43:10 PM »
Very nice!

19
Technical Talk / Re: Possible system enhancement
« on: October 17, 2017, 07:29:34 PM »
Fair enough. Do you know the refresh rate off hand? Maybe I can play with frame rates too..

20
Technical Talk / Re: Possible system enhancement
« on: October 17, 2017, 06:35:07 PM »
I like it. On the subject of the display though, is there also a way to make it refresh all digits at the same time? I have noticed that my gopro really doesn't like the refresh rate (when recording at 60 fps) and it makes it hard to see the time. Example: https://youtu.be/YBdIJrJw_78?t=47s

I'm sure you are already aware of it, but thought I'd ask. :)

21
SASC Events / Re: Sunday, October 1 - Champioinship #13
« on: September 30, 2017, 12:35:52 PM »
Thanks guys. Have fun!

22
SASC Events / Re: Sunday, October 1 - Champioinship #13
« on: September 30, 2017, 09:05:33 AM »
Is there a way to remove yourself from registration on msreg? Unfortunately it hit the fan at work on Friday and I'll be tied up fixing things on Sunday. :(

23
SASC Events / Re: Re: Scores for September 17, 2017 event at YYC
« on: September 18, 2017, 12:00:00 PM »
Quick brake tap right at the end of the slalom to set the front end and get the car to rotate, then keep it tight all the way around the right hander.


https://youtu.be/YBdIJrJw_78

24
SASC Events / Re: Scores for September 17, 2017 event at YYC
« on: September 17, 2017, 08:30:24 PM »
Thanks everyone for an awesome event! Great track and everyone was on the ball. Had a blast as usual.

These two-day weekends are tough though, my arms are killing me!

25
SASC Events / Re: Sun, Sept 17 Championship registration is open!
« on: September 16, 2017, 03:23:47 PM »
Ok just to confirm, meeting at the lot instead of storage?

26
SASC Events / Re: Sun, Sept 17 Championship registration is open!
« on: September 15, 2017, 09:12:47 PM »
I'll help too.

27
General Discussion / Re: Cardel Park and Polish
« on: September 06, 2017, 06:18:04 PM »
D'oh! I made a stupid. Am a week ahead of myself!

28
General Discussion / Re: Cardel Park and Polish
« on: September 06, 2017, 04:41:51 PM »
Think most of us will be racing. ;)

29
Automotive Marketplace / FS: Mazda RX-8
« on: August 31, 2017, 07:36:09 PM »
Vehicle Details
Year : 2005
Make and Model : Mazda RX-8
Exterior Color :  Blue
Interior Color :  Black
Auto or Manual? : Manual 6 spd
Odometer Reading : 102,000 km
Location of Vehicle : Calgary
Description : See below
Extras : See below
Asking Price : $7000

Contact Information
PM

NOTE: Will be available mid-september, need another couple events to qualify in points this year.

Up for sale is my RX-8 with rebuilt engine as seen HERE.

I initially bought this to have a project, and it's been the perfect project for me, but now I am moving on to something more ambitious; building a car from scratch.

This car is a great car to autocross. Very predictable handling, and generally does pretty well in its class. Currently it is in STX class due to the high flow cat and wheels. Add a set of coilovers and it will really come alive.

The tires are of course Bridgestone RE-71r in 245/45/17, just put on in July and have around 20 runs on them, so LOTS of life left. The wheels are OEM SN95 Mustang rims (with blank center caps, didn't want the pony logo lol). They have anodized aluminum hubcentric rings and I chose them because they are 17x8 with a nice offset and forged aluminum, only 19 lbs each. No curb rash on any of them (6 in total, see the extras section for more info)

I have been very meticulous with this thing and have put a lot of time and effort into getting everything just right. The engine is rebuilt with about 10,000km on it and runs flawlessly. Always starts on the first try, cold or hot. Clean carproof too!

While the engine was apart I cleaned everything. Every part of the intake manifold, exhaust, every internal part obviously.. I spent a lot of time on this part and it's not something the shops normally do. All the internals were in great shape. The engine failed due to carbon buildup which caused low compression. This is a leading cause of engine failure, especially with cars that only see city driving and never get redlined. The old rotary addage "a redline a day keeps the carbon away" is very true. I used the car to commute to work for the first 5000 kms to properly break in the engine, since then it has mainly just been driven to and from autox events in Red Deer and Fort Macleod. Every single tank of gas has been run with premix and the Sohn adapter was installed at the same time as the engine. Just ordered a full case of Idemitsu which will last a long, long time.

Here's a quick rundown of the major parts:

-Rebuilt Renesis engine with full OEM kit (all seals, gaskets, etc)
--Oil pressure mod (shimmed regulator to bump pressure)
--Sohn adapter (injects premix instead of dirty used engine oil)
--GM D585 ("LS2") coils with new MSD wires and new spark plugs
--New OEM oil injectors (Nobody ever thinks to change these, but they can get gummed up, so I did)
--New oil injector lines (properly run and crimped)
--New thermostat
--Atkins solid thermal pellet
-New Excedy clutch with FD pressure plate (slightly higher clamp force) and resurfaced flywheel
-New Race Roots motor mounts
-Race Roots synchro saver
-Racing Beat catback exhaust
-Racing Beat downpipe with Vibrant metal high flow cat
-Whiteline front swaybar (with new OEM endlinks)
-New Hawk HPS pads all around
-New Optima redtop battery
-New starter (the revised, higher speed one)
-Walbro 255 fuel pump
-K&N drop-in filter and airbox debaffled (JDM spec)
-Racing Beat oil cooler screens
-New windshield installed last year
-3m coating on the front end

I've taken care of all the usual things that give RX8 owners grief, including:

-Resoldered all contacts on heater control
-Replaced motor mounts (stock ones go at around 100k)
-Disassembled, cleaned and greased all connectors in the electric power steering


Extra parts included:
-Set of OEM 18" wheels and all season tires, all in good shape
-2 extra race wheels (exact same style, Mustang wheels) with tires that are nearly bald, but not corded or anything
-Stock cat and catback
-Stock windshield wiper fluid reservoir (currently has a US-spec reservoir to fit the Sohn bottle)
-Stock front swaybar

GT package includes:
-Heated leather seats
-Power sunroof
-Fog lights
-Sport suspension (brakes, shocks, and springs,)
-Bose audio
-Power driver seat
-HID headlights
-Homelink mirror (garage door opener)
-Traction control and Dynamic Stability Control, which works pretty well but can also be turned completely off. :)

Gripes I have are:
-HVAC controls don't light up at night. Needs a new bulb maybe?
-Faint clunk from, I think, the PPF. I have spent HOURS going through the whole front end and can't find anything. Even went as far as using a magnetic microphone everywhere I could think of, but came up empty. Probably an old bushing somewhere, but it certainly doesn't show in the handling of the car. Everything feels very tight (I even get comments like that when other RX8 owners drive it).
-Couple scuffs here and there on the paint, most of them from before I owned it
-I did take out a runway light at a Fort Macleod event. Small dent in the RR rocker that I have to point out for people to notice. Have not tried to pull it out yet, been thinking about getting some OEM side skirts actually...
-The interior is generally in very good shape, I stripped a lot of parts and cleaned them when I got it, but there is the usual wear on the driver seat bolster.
-Bit of surface rust under the spoiler and inside the gas cap. Been meaning to take care of this but haven't been able to find the paint locally. Might order some..

PICS:








More here: http://imgur.com/a/FTfiL

VIDEOS:
https://youtu.be/pcBwJMmUNMg
https://youtu.be/8JIRUoYP8-Y


BOTTOM LINE:

I have no qualms with keeping the car until the other one is finished, and may even run it in the winter ice dice. But I thought I may as well post it now in case someone is looking. I would consider trading for something else interesting, as long as it's straight across or + cash on your end. Would consider something AWD like a RHD subaru / Celica GT-four or...??

30
SASC Events / Re: Red Deer Championship #9 - Joint CSCC/SASC series
« on: August 05, 2017, 08:42:38 PM »
Crap, got tied up and missed registration. Is on-site reg ok this time?

Pages: 1 [2] 3 4